American QMP housings, Chloramine Rated Pre filter, Pressure gauge
This Reverse Osmosis Undersink 4 Stage model PSI-021-4PG is a premium low waste 1 to 1 ratio unit configured specifically for treatment of Chloramines. Chloramines is a combination of Chlorine and Ammonia together. Optional ALKALIZER
It has the Dow Filmtec 300 litre per day TFC membrane, the 300 litres is rated at 50 psi (350 kpa) but will produce up to 450 litres per day higher pressures, what this means is the system will fill faster than most systems on the market. This system has an auto shut-off device that closes off the in-feed supply when the storage tank has filled.
Main filter unit size dimensions-
42 cm high, 35 cm wide & 14 cm deep.
Storage Tank dimensions-
4.2L - 33cm high and 20.5cm diameter
9L - 39cm high and 24cm diameter
12L- 39cm high and 27.5cm diameter
Optional Faucet Designs-
Click here to view.
Supplied with QMP-300-HP U.S.A. made housing 10" Australian Standards AS3497 with 1/4" NPT threaded ports. This housing is tough with a burst strength of 575psi (4000kpa) and is tested to AS3497 which means it has been tested from 0 to 700kpa and back to 0 kpa 100,000 times without failure, cracking or distortion.
With these premium systems we supply the 550kpa pressure limiting valve with dual check valves which is a plumbing code requirement, the valve is also Watermark AS1357-2 licence no 23133 as the watermark is also a plumbing code requirement.
We supply the 550pa PLV with the premium system so the filter system runs faster than other units on the market.
It has the Dow Filmtec 300 litre per day TFC membrane, the 300 litres is rated at 50 psi (350 kpa) but will produce up to 450 litres per day higher pressures, what this means is the system will fill faster than most systems on the market. This system has an auto shut-off device that closes off the in-feed supply when the storage tank has filled.
All components are NSF certified to standards 042, 053 or 058
Removes 96 to 98% of Fluoride, for membrane treatment rates click here.
Filter Replacement Links-
Annual set of cartridges (sediment , carbon pre filters & carbon post filter)
Replacement Membrane (3-4years)
Replacement remineraliser( If the system is fitted with one)
1 Micron food grade polyspun sediment filter 9 ¾" (248mm) (standard size) U.S. made
Matrikx CTO Chloramine carbon block
Genuine Omnipure CL10RO-T40 Coconut carbon post filter, highest quality possible. U.S. made
Genuine Dow Filmtec TFC Membrane (standard by which all other membranes are measured)
Premium systems now have the lowest waste ratio of all systems on the Australian market, using a Patented combination membrane flushing valve/flow restrictor means the waste ratio is about 50% less waste than other brands, waste ratio is now about 1 to 1.
Click here to obtain more information about waste ratios
Installation choice 1/2" tee olive fitting, 3/4"dishwasher adapter or 1/2" easy fit braided line flick mixer adapter, our systems take the average plumber 1/2 to 1 hour to install
Mains connect systems click here to view how each are installed
10 year warranty
Click here for selection Advice
PSI Systems are Better Than Other Brands, click here to find out why
All reverse osmosis systems require a minimum pressure of 40 psi (280kpa) with 50 psi (350kpa) or more is ideal. If you are unsure what your pressure is check with your local Council or water authority.
Product comes complete, ready for installation.
Substance treatment rates below for TFC reverse osmosis, click here for a full list in PDF.
The model PSI-021-4PG is a 4 stage undersink reverse osmosis unit designed to treat water from the mains supply that has been treated with chloramines.
A normal reverse osmosis system will not treat the ammonia component of chloramine which is a combination of chlorine and ammonia together. The reason the ammonia cannot be treated with a normal non chloramine system is the ammonia is in a gas form and not a liquid and as a result will pass through the membrane. A normal (non chloramine) system will treat the chlorine component of chloramine but will liberate the ammonia which will pass through the system and remain in the product water.
The carbon pre-filter in a chloramine system such as the PSI-021-4PG is what is called catalytic carbon which results in the successful treatment of the chloramine while the chlorine and the ammonia are still chemically bonded.
There are 2 levels of chloramine carbon, catalytic carbon and enhanced carbon with the catalytic carbon being the superior of the two when it comes to treatment of chloramines. Both are coconut based carbons but both are treated in a special way which remains a secret by the manufactures with the catalytic being the most difficult to manufacture and that is reflected in the higher cartridge cost. In this system we use the Matrikx CTO chloramine catalytic carbon cartridge and can be viewed at this replacement cartridge page link.
This model is one of our premium range which is second to nothing on the market when it comes to reliablity which will result in faultless years of operation if maintained correctly.
Chloramine systems such as this model will cost on average $20.00 per year more to run than the non chloramine systems which is good value when you think about drinking low doses of ammonia.
Chloramine systems such as this one will not treat the ammonia if there is a whole house system installed which has a carbon based cartridge which is not catalytic carbon because once the chlorine and ammonia are split and no longer chemically bonded the catalytic carbon cannot treat ammonia on its own. If you have a whole house system then it is that unit which should have the chloramine (catalytic) carbon in it and the reverse osmosis system only needs to be a normal type. The reason for this is the first carbon of contact the water makes from the mains supply needs to be chloramine carbon system.
Sydney and Brisbane water is treated with chloramines but there are also some smaller regional areas that are also treated with chloramines and it is hard for us to keep track of all treatment plants around the country so if you are not sure we suggest you contact your local water authority and ask them as you have that right. If you purchased a chloramine system such as this one it will perform brilliantly with chlorine only water and if you found out later that the water was for sure only treated with chlorine you can drop back to a normal carbon pre-filter saving a few dollars.